DYNAMIC TESTS
TEC EUROLAB
TEC Eurolab performs mechanical stress tests on your components
VERIFY your product’s ability to withstand and distribute mechanical loads
Dynamic tests carried out at TEC Eurolab’s Test Engineering department
- Custom tests for wear simulation
- Impact tests
- Mechanical tests on real components
- Flexion, traction, compression tests with experimental setup
- Multi-axial fatigue tests up to 25kN
- Vibration tests
- NVH (Noise-Vibration-Harshness) acquisition and analysis
Using pneumatic and electromechanical actuators, we configure a test set-up that faithfully reproduces the stress state the component will encounter during its service life.
REAL-TIME CONTROL OF ACTUATOR MOVEMENT
The real-time actuator motion control system will allow you to manage up to 4 axes simultaneously, with loads ranging from a few newtons (required for biomedical components) up to 25kN (massive mechanical components). Static or dynamic test cycles can be programmed, according to a plan tailored to your specific needs.
MODULAR TEST BENCHES
TEC Eurolab takes full advantage of the modularity of specific test benches. In this way, any test setup can be set up to simulate all modes of mechanical stress. Furthermore, by interfacing auxiliary control systems to the benches, it is possible to set up torsion tests and functional wear simulation tests.
The laboratory also has various acquisition systems with sensors, to be able to guarantee the acquisition of the greatest quantity of information to provide a detailed picture of the distribution of stresses and deformations on the component.